Saturn Outlook

Saturn Outlook

Model Overview

No model overview available

Explore Saturn Outlook

Photos

No content available

Reviews and News

Owner Scores

Based on 8 reviews
Comfort N/A
0% Complete
Performance N/A
0% Complete
Fuel Economy N/A
0% Complete
Interior Design N/A
0% Complete
Exterior Styling N/A
0% Complete
Reliability N/A
0% Complete

Owner Reviews

Steve5073 Great SUV December 23, 2015
Overall Score
Great vehicle all around for really good value! I've owned many different brands and types of cars and have genuinely preferred my Outlook more than all others, including an Infiniti.
Comfort 10
100% Complete
Performance 10
100% Complete
Fuel Economy 10
100% Complete
Interior Design 10
100% Complete
Exterior Styling 10
100% Complete
Reliability 10
100% Complete
View all owner reviews

Recall Information

Recall number
Recall date
System affected
Model year(s) affected
Recall number
2015-280
Recall date
2015-06-25
System affected
Structure
Model year(s) affected
2007 2008 2009
Manufacturer Recall Number:
15240
Units Affected:
36,369
Notification Type:
Safety Mfr
On certain vehicles equipped with a power liftgate system, the gas-filled struts (which help to raise and support the liftgate) may prematurely wear. These vehicles have a Prop Rod Recovery system intended to accomplish a controlled, slow return of the liftgate to the closed position if the liftgate’s gas struts are no longer capable of supporting the weight of the liftgate. The vehicle would provide audible warnings and flash the tail lamps to indicate there is a problem. However, the liftgate’s Prop Rod Recovery system software may be unable to detect/stop a liftgate with prematurely worn gas struts from falling too quickly after the liftgate is opened. This could allow the liftgate to drop suddenly, placing anyone beneath or near the gate at risk of injury. Correction: Dealers will reprogram the power liftgate actuator motor ECU with a new software and will verify power liftgate operation following the reprogram.
Recall number
2014-181
Recall date
2014-05-21
System affected
Seats And Restraints
Model year(s) affected
2009 2010 2011 2012 2013 2014
Manufacturer Recall Number:
14187
Units Affected:
75,701
Notification Type:
Safety TC
On certain vehicles, the flexible steel cable that connects the seat belt to the vehicle structure at the front outboard seating positions can fatigue over time and could separate, increasing the risk of injury in a crash. Correction: Dealers will inspect and repair or replace the lap pretensioner, as necessary.
Recall number
2014-081
Recall date
2014-03-18
System affected
Airbag
Model year(s) affected
2008 2009 2010
Manufacturer Recall Number:
14030
Units Affected:
70,526
Notification Type:
Safety Mfr
On certain vehicles, side airbag wiring connections could develop high resistance, illuminating the airbag warning light. If the vehicle continues to be operated in this condition, resistance may continue to increase over time and eventually cause the seat side airbags and seat belt pretensioners to not deploy in the event of a crash, which could increase the risk of injury. Correction: Dealers will affect repairs.
Recall number
2010-276
Recall date
2010-08-16
System affected
Seats And Restraints
Model year(s) affected
2009 2010
Manufacturer Recall Number:
10243
Units Affected:
16,752
Notification Type:
Safety Mfr
On certain vehicles, the second row seat side trim shield may restrict the upward rotation of the safety belt buckle when the seat back is returned to a seating position after being folded flat. If the buckle contacts the seat frame, additional effort is required to return the seat to a seating position. If sufficient force is applied, the buckle cover could be pushed down the strap, exposing and partially depressing the red release button. As a result, the release button will not travel as much as designed when depressed and will appear to be jammed. The buckle cover may have visible damage which may only be cosmetic, but in some cases, the buckle may not latch/unlatch, or may appear to latch when the latch mechanism is not fully engaged. If the latch mechanism is not fully engaged, the safety belt may not restrain the occupant as intended in a crash, which could result in personal injury or death. Correction: Dealers will modify the second row seat side trim shields, inspect the belt buckle and will replace it if damaged.
Recall number
2010-189
Recall date
2010-06-07
System affected
Accessories
Model year(s) affected
2007 2008 2009
Manufacturer Recall Number:
10153
Units Affected:
99,000
Notification Type:
Safety Mfr
On certain vehicles equipped with a Heated Washer Fluid System (HWFS), a short circuit on the printed circuit board for the washer fluid heater may overheat the control-circuit ground wire. A repair was implemented in a recall in 2008, however, there have been new reports of thermal incidents on heated washer fluid system modules after this improvement was installed. This situation may cause some minor distortion, but also could lead to melting of the plastic around the heated washer fluid system, or cause a fire. Correction: Dealers will permanently disable and remove the heated washer fluid module. An updated page will be provided and inserted in the Owner Manual to document the removal of the feature.
Recall number
2009-076
Recall date
2009-03-11
System affected
Other
Model year(s) affected
2009
Manufacturer Recall Number:
09041 09077
Units Affected:
31,458
Notification Type:
Safety Mfr
On certain vehicles, the transmission shift cable adjustment clip may not be fully engaged. Should this occur, the shift lever and the actual position of the transmission gear may not match. As such, the driver could move the shifter to PARK and remove the ignition key, but the transmission gear may not actually be in the PARK position. This could allow the vehicle to roll away, possibly causing property damage and/or personal injury or death. Correction: Dealers will inspect and, if required, replace the shift cable.
Recall number
2008-424
Recall date
2008-11-25
System affected
Seats And Restraints
Model year(s) affected
2009
Manufacturer Recall Number:
08387
Units Affected:
536
Notification Type:
Compliance TC
Certain vehicles fail to comply with the requirements of CMVSS 209 - Seatbelt Assemblies. These vehicles may have been assembled with a safety belt buckle in the second or third row that is missing a rivet. In a vehicle crash, this could allow the buckle to separate from the mounting strap. As a result, the seat occupant may not be restrained as intended, which could cause personal injury or death. Correction: Dealers will inspect the seatbelt buckles in the second and third rows, and replace them if necessary.
Recall number
2008-313
Recall date
2008-08-29
System affected
Other
Model year(s) affected
2007 2008
Manufacturer Recall Number:
08048
Units Affected:
54,431
Notification Type:
Safety Mfr
On certain vehicles equipped with a heated washer fluid system, a short circuit on the printed circuit board for the washer fluid heater may overheat the control-circuit ground wire. This situation may cause other electrical features to malfunction which could cause smoke and in some cases a fire. Correction: Dealer will install a wire harness with an in-line fuse.
Recall number
2008-283
Recall date
2008-08-13
System affected
Other
Model year(s) affected
2007 2008
Manufacturer Recall Number:
08091
Units Affected:
16,533
Notification Type:
Safety Mfr
On certain vehicles registered in areas with moderate to heavy snowfall, a buildup of snow or ice on the windshield or wipers could restrict the movement of the wiper arm and the wiper linkage may become detached from motor shaft and the wipers will become inoperative. This situation, in conjunction with traffic, road conditions, and driver's reactions, could increase the risk of a crash. Correction: Dealers will install a new wiper crank arm, driver's side link, and crank arm nut.
Recall number
2007-044
Recall date
2007-02-22
System affected
Airbag
Model year(s) affected
2007
Manufacturer Recall Number:
07043
Units Affected:
1,079
Notification Type:
Safety Mfr
On certain vehicles, the sensing and diagnostic module (SDM), which controls the function of front airbags, may not operate properly. As a result, the front airbags may fail to deploy in a frontal crash. Also, the airbag warning lamp in the instrument panel may fail to provide warning that the system is inoperative. Failure to deploy the front airbags during a crash could leave seat occupants susceptible to increase injuries. Correction: Dealers will re-program the SDM.
Select Another Vehicle
Search now