Issue:
This recall is for aftermarket replacement rear window glass produced by Vitro Automotriz. Certain rear window glass may not have been properly tempered. If the window breaks, the glass may separate into large pieces instead of very small ones.
Note: This is a voluntary recall that is not being conducted under the requirements of the Motor Vehicle Safety Act.
Safety Risk:
Glass that breaks in to large pieces could create a risk of injury.
Corrective Actions:
The company will notify consumers by mail and instruct them to inspect the designation code marked on the rear window glass. Products affected by this recall have the designation “DOT 287” along with the lettering “VMR” (Replacement Market) and a date code that is before July 2019. This information is printed on the bottom corner of the glass. Consumers should contact Vitro's customer service at 1-412-995-6457 or argbacklites@vitro.com to arrange for replacement of the glass.
On certain Aztek (AWD), Montana (AWD), Relay (AWD), RendezVous (AWD), RendezVous (FWD), Silhouette (AWD), Terraza (AWD), Terraza (FWD), Uplander (AWD) and Venture (AWD) vehicles equipped with independent rear suspension, when operated in extreme cold temperature and on rough roads, water and salt can intrude past the ball joint seal. The combination of theses conditions may then lead to premature wear of the ball joint. If the ball joint wear progresses to the point of separation from the lower control arm, a loss of vehicle control may occur. Correction: Dealers will replace both ball joints with new ball joints which have a revised boot and ball stud to improve the seal to the ball stud shaft.
On certain vehicles, the outboard release handle on the impact-side second-row bucket seat may be actuated and the rear latches may unlatch early during the crash sequence of a side impact New Car Assessment Program (NCAP) test. If the rear latches of the seat are released early in a severe side impact, the front outboard latch may disengage and increase the potential for injury to the occupant of the seat. Correction: Dealers will replace the seat latch release lever.
On certain vehicles equipped with second-row bucket seats or captain's chairs and power sliding door on the passenger side, if a passenger uses the interior handle to open the power sliding door and holds onto the handle while it is being opened by the motor, the passenger's arm may be pushed into the seat back or armrest and a wrist or lower arm injury may result. Correction: Dealers will replace the original interior power sliding door handle. The original handles are offset from the door panel and a passenger can wrap his or her fingers around them. The replacement door handles are essentially flush with the door trim, preventing a passenger from gripping them in the same fashion.
Certain vehicles do not comply with CMVSS 225 and 210.2. The Owner's Manual does not include the location symbols for the Lower Universal Anchorage System for Restraint Systems and Booster Cushions and an explanation of the meaning of the symbols. Correction: Owner's will receive an Owner's Manual supplement.
On certain vehicles, the driver's side air bag may not deploy as designed, resulting in reduced capability of the air bag to protect the driver. In addition, the air bag inflator may fracture. If this were to occur, pieces of the inflator could strike and injure the vehicle occupants. Correction: Dealer will inspect, and if necessary, install a new driver's air bag.
On certain vehicles, the passenger air bag was manufactured without a check pin. An air bag without the check pin could produce increased pressure at the onset of the air bag deployment and reduced pressure afterward. This could increase the severity of injury to a person who was not properly restrained and who was close to the passenger air bag at the time of deployment. It could also reduce the ability of the air bag to protect a restrained front seat passenger. Correction: Dealers are to inspect, and if necessary, replace the passenger air bag.
Certain vehicles may have a driver's side airbag inflator that could fracture at a weld during a deployment. Pieces of the inflator could strike and injure vehicle occupants and the airbag cushion would not inflate fully, reducing the capacity of the bag to protect the driver. Correction: Dealers are to inspect and if necessary replace the driver side airbag module assembly.
Certain 1997-2001 Chevrolet Venture, Pontiac Montana/ Trans Sport, and Oldsmobile Silhouette mini vans equipped with passenger side power sliding doors that were serviced in campaign 01013 (01v-067) from April to August 2001. Also 2001 Chevrolet Venture, Pontiac Montana, and Oldsmobile Silhouette mini vans equipped with passenger side power sliding doors assembled in January through April 2001. These vehicles have inadequate front welds. If a front weld fails, the actuator can jam in the unlatched position and, when the sliding door closes, it will not be latched. If this happens, the power sliding door can open while the vehicle is in motion, particularly when the vehicle ascends a hill, makes a turn, or travels over a rough road surface. An unrestrained occupant could fall out of the van and be injured. Correction: dealers will inspect the actuators for certain date codes and, if necessary, replace the actuators.
Certain vehicles may exhibit a condition in which the power sliding door closes, but is not latched, If this happens the power sliding door can open while the vehicle is in motion, particularly when the vehicle ascends a hill, makes a turn, or travels over a rough road surface. An unrestrained occupant could fall out of the vehicle and be injured. Correction: Dealers will install a new power sliding door un-latch actuator assembly.
Certain vehicles do not comply with the requirements of C.M.V.S.S. 209 - Seat Belt Assemblies. Vehicles may have seat belt assemblies that will not withstand the force requirements of the standard. In a crash, if the belt buckle fails, there is an increased risk of injury to the occupant. Correction: Suspect buckle assemblies will be replaced.
Subscribe for the latest car reviews, listings, products and more right in your inbox.
By clicking 'Subscribe', I agree to receive communications from AutoTrader. I can unsubscribe at anytime. I also agree to the Terms of Use and Privacy Policy.