Back to login
Pontiac Aztek
Photos
No content available
Reviews and News
Owner Scores
Comfort
N/A
Performance
N/A
Fuel Economy
N/A
Interior Design
N/A
Exterior Styling
N/A
Reliability
N/A
Owner Reviews
JohnFKenndy2013
replaced head casket 3 times in 200 km
November 26, 2013
Overall Score
poor visability for tall driver, rough ride in four wheel version, no rear wiper, tail gate drops down making poor trunk accessability,over size convex side mirrors that i found inaffective, poor location for interior light,seats did fold up well for cargo, never used tent, it did have great traction in snow and was fun for weekend ski trips to lake louise , if it had toyota engine would be good suv , the sun visor would not stay in position very fustrating but i could always find the bright yellow and black car in the parking lot
Comfort
6
Performance
6
Fuel Economy
4
Interior Design
6
Exterior Styling
8
Reliability
2
Recall Information
* Data provided by Transport Canada
Recall number
Recall date
System affected
Model year(s) affected
Recall number
2006-199
Recall date
2006-08-15
System affected
Suspension
Model year(s) affected
2001 2002 2003 2004 2005
Manufacturer Recall Number:
06089
Units Affected:
49,116
Notification Type:
Safety TC
On certain Aztek (AWD), Montana (AWD), Relay (AWD), RendezVous (AWD), RendezVous (FWD), Silhouette (AWD), Terraza (AWD), Terraza (FWD), Uplander (AWD) and Venture (AWD) vehicles equipped with independent rear suspension, when operated in extreme cold temperature and on rough roads, water and salt can intrude past the ball joint seal. The combination of theses conditions may then lead to premature wear of the ball joint. If the ball joint wear progresses to the point of separation from the lower control arm, a loss of vehicle control may occur. Correction: Dealers will replace both ball joints with new ball joints which have a revised boot and ball stud to improve the seal to the ball stud shaft.
Recall number
2005-113
Recall date
2005-04-21
System affected
Electrical
Model year(s) affected
2004
Manufacturer Recall Number:
05014
Units Affected:
3,760
Notification Type:
Safety Mfr
On certain vehicles, contamination on ignition relay contacts can cause high resistance. This can affect signals to the powertrain control module, which could result in intermittent engine stalling. In some cases, the vehicle cannot be restarted immediately. If this were to occur, it could result in a vehicle crash. Correction: Dealers will replace the ignition relay.
Recall number
2004-028
Recall date
2004-01-23
System affected
Wheels
Model year(s) affected
2003
Manufacturer Recall Number:
Units Affected:
6,168
Notification Type:
Compliance Mfr
On certain vehicles, the aluminum wheels are not marked with "T" and "DOT" as required by CMVSS 120. Correction: Since this does not pose any safety risk, no corrective action is required.
Recall number
2003-266
Recall date
2003-11-04
System affected
Fuel Supply
Model year(s) affected
2004
Manufacturer Recall Number:
03055
Units Affected:
9
Notification Type:
Safety Mfr
On certain vehicles, a weld between the fuel tank inlet valve and the fuel tank was not made to specification and can fail. If these parts separate, the driver may notice an odour of fuel, the Service Engine Soon or Check Engine light may illuminate, and/or fuel may leak onto the ground. If a sufficient amount of fuel leaked and if an ignition source were present, a vehicle fire could occur. Correction: Dealer will inspect the fuel tank and replace it if necessary.
Recall number
2003-172
Recall date
2003-07-16
System affected
Seats And Restraints
Model year(s) affected
2003
Manufacturer Recall Number:
03039
Units Affected:
54,634
Notification Type:
Compliance TC
Certain vehicles do not comply with CMVSS 225 and 210.2. The Owner's Manual does not include the location symbols for the Lower Universal Anchorage System for Restraint Systems and Booster Cushions and an explanation of the meaning of the symbols. Correction: Owner's will receive an Owner's Manual supplement.
Recall number
2003-036
Recall date
2003-02-14
System affected
Steering
Model year(s) affected
2003
Manufacturer Recall Number:
03009
Units Affected:
728
Notification Type:
Safety Mfr
On certain vehicles, the steering column intermediate shaft is undersized, which could allow the intermediate shaft to spin inside the steering column coupling resulting in loss of directional control of the vehicle. If this were to happen while the vehicle is moving, a crash could result without prior warning. Correction: Dealer will inspect, and replace if necessary, the steering column intermediate shaft.
Recall number
2002-234
Recall date
2002-12-04
System affected
Airbag
Model year(s) affected
2001
Manufacturer Recall Number:
02061
Units Affected:
127
Notification Type:
Safety Mfr
On certain vehicles, the passenger air bag was manufactured without a check pin. An air bag without the check pin could produce increased pressure at the onset of the air bag deployment and reduced pressure afterward. This could increase the severity of injury to a person who was not properly restrained and who was close to the passenger air bag at the time of deployment. It could also reduce the ability of the air bag to protect a restrained front seat passenger. Correction: Dealers are to inspect, and if necessary, replace the passenger air bag.
Select Another Vehicle