Back to login
Lexus RX 330
Photos
No content available
Reviews and News
Owner Scores
This vehicle has not yet been reviewed
Recall Information
* Data provided by Transport Canada
Recall number
Recall date
System affected
Model year(s) affected
Recall number
2011-397
Recall date
2011-11-09
System affected
Steering
Model year(s) affected
2004 2005
Manufacturer Recall Number:
SSC 152 / SSC 153
Units Affected:
23,003
Notification Type:
Safety Mfr
On certain vehicles equipped with a 1MZ-FE or 3MZ-FE V6 engine, the crankshaft pulley may fail. The outer ring may become misaligned, or it may not properly rotate, causing noise and/or illumination of the discharge warning light. In addition, the power steering belt may become detached from the crankshaft pulley, which could result in a sudden increase in steering effort. A loss of steering power assist could result in a crash causing property damage and/or personal injury. Correction: Dealers will inspect and, if necessary, replace the crankshaft pulley.
Recall number
2011-081
Recall date
2011-02-24
System affected
Other
Model year(s) affected
2004 2005 2006 2007
Manufacturer Recall Number:
143, 144
Units Affected:
30,428
Notification Type:
Safety Mfr
On certain vehicles, if the forward retention clip used to secure the floor carpet cover, which is located in front of the center console, is not installed properly, the cover may lean toward the accelerator pedal and interfere with the operation of the accelerator pedal arm. If this occurs, the accelerator pedal could temporarily become stuck in a partially depressed position, rather than return to the idle position. This could result in a loss of throttle control and a crash causing property damage and/or personal injury. Correction: Dealers will replace the floor carpet cover with a newly designed version. Note: This campaign also covers vehicles which may have been previously included in recall 2006168 (Toyota 609).
Recall number
2010-361
Recall date
2010-10-21
System affected
Brakes
Model year(s) affected
2004 2005 2006
Manufacturer Recall Number:
127, 128
Units Affected:
28,679
Notification Type:
Safety Mfr
Certain vehicles use brake fluids containing polymers that act as lubricants for certain brake system components. If during vehicle maintenance, brake fluid is used that does not contain such polymers or only small amounts, part of the internal rubber seal located at the end of the brake master cylinder piston may become dry and may curl during movement of the piston. If this occurs, a small amount of the brake fluid could slowly leak from the brake master cylinder into the brake booster, resulting in illumination of the brake warning lamp. If the brake warning light has illuminated and the vehicle continues to be operated without refilling the master cylinder brake fluid reservoir, the driver will begin to notice a spongy or soft brake pedal feel and braking performance may gradually decline. This will increase the stopping distance, increasing the likelihood of a crash. Correction: Dealers will replace the brake master cylinder seal with a newly designed one.
Recall number
2006-168
Recall date
2006-07-11
System affected
Other
Model year(s) affected
2004 2005 2006
Manufacturer Recall Number:
609
Units Affected:
14,510
Notification Type:
Safety Mfr
On certain vehicles, due to the improper installation of the retaining clips for the floor carpet cover located in front of the center console, there is a possibility that the clips may become loose. If both clips separate from the floor carpet cover, the cover may lean toward the accelerator pedal, causing interference with the accelerator pedal rod. In the worst case, the accelerator pedal may become stuck in a partially depressed position when returning to the idle position. Correction: Dealers will install new clips.
Recall number
2006-021
Recall date
2006-01-26
System affected
Seats And Restraints
Model year(s) affected
2004
Manufacturer Recall Number:
Units Affected:
391
Notification Type:
Safety TC
Certain vehicles do not comply with the requirements of CMVSS 210. The left rear seat belt buckle anchor may separate from the floor before holding the required test load for the required time. If a separation occurred in a crash, the left rear seat occupant may not be properly restrained, increasing the risk of personal injury. Correction: Dealers will replace the left rear seat belt buckle anchor bolt.
Recall number
2004-409
Recall date
2004-11-23
System affected
Electrical
Model year(s) affected
2004
Manufacturer Recall Number:
501 & 502
Units Affected:
8,568
Notification Type:
Safety Mfr
On certain vehicles equipped with a light emitting diode (LED) stop lamp, there is a possibility that silicon oxide may be generated on the surface of the contact point inside the stop lamp switch. Consequently, current may not flow at the contact, causing the stop lamp to become inoperative. The loss of stop lamps would result in failure to warn following drivers that the vehicle is braking and/or is stopped, which could lead to a vehicle crash. Correction: Dealers will replace the stop lamp switch.
Select Another Vehicle