Had a few problems with this car and I prefer a sedan so maybe this wasnt the car for me, I really wanted to buy the lastest generation SS version but couldnt get my hands on one.
On certain vehicles equipped with a 3.8L engine, degradation of the front rocker cover gasket may result in eventual oil seepage. Under hard braking, drops of engine oil may be deposited on the exhaust manifold. If the manifold is hot enough and the oil runs below the heat shield, it may ignite into a small flame and, in some instances, the fire may spread to the plastic spark plug wire channel and beyond. An under-hood fire could result in injury and/or property damage. Correction: Dealers will replace the engine’s front valve cover and front-valve-cover gasket with new parts. The engine’s plastic “beauty” cover and plastic oil-fill-tube extension will also be removed, if they haven’t been already. Note: This recall supersedes and is an expansion of recalls 2008-081, 2009-105 and 2015-145. All vehicles having been inspected and/or serviced under the previous recall will require re-inspection and repair.
On certain vehicles, a defect in the ignition switch could allow the switch to move out of the "run" position if the key ring is carrying added weight or the vehicle goes off-road or is subjected to some other jarring event. If this were to occur, engine power, power steering and power braking would be affected, increasing the risk of a crash causing injury and/or damage to property. The timing of the key movement out of the “run” position, relative to the activation of the sensing algorithm of the crash event, may also result in the airbags not deploying in a subsequent collision, increasing the risk of injury. Correction: For each key, dealers will install two key rings and modify the key ring opening shape. Note: Until the correction is performed, all items should be removed from the key ring.
On certain vehicles, a defect in the ignition switch could allow the switch to move out of the "run" position if the key ring is carrying added weight or the vehicle goes off-road or is subjected to some other jarring event. If this were to occur, engine power, power steering and power braking would be affected, increasing the risk of a crash causing injury and/or damage to property. The timing of the key movement out of the “run” position, relative to the activation of the sensing algorithm of the crash event, may also result in the airbags not deploying in a subsequent collision, increasing the risk of injury. Correction: For each key, dealers will install two key rings and modify the key ring opening shape. Note: Until the correction is performed, all items should be removed from the key ring.
On certain vehicles equipped with a 3.8L naturally aspirated engine, degradation of the front rocker cover gasket may result in eventual oil seepage. Under hard braking, drops of engine oil may be deposited on the exhaust manifold. If the manifold is hot enough and the oil runs below the heat shield, it may ignite into a small flame and, in some instances, the fire may spread to the plastic spark plug wire channel and beyond. An under-hood fire could result in property damage, personal injury or death. Correction: Dealers will remove the spark plug wire retention channel at the front of the engine and install two new-revised spark plug wire retainers.
On certain vehicles, two bolts that attach the front brake caliper to the steering knuckle on the left and right front wheel assemblies were not tightened adequately. If too much movement occurs between the caliper bracket and knuckle, the bolt(s) may back out or fracture. Depending on whether one or both bolts back out or fracture, the result can be: 1) locking of the affected wheel during braking and an abrupt steering input in the direction of the locked wheel, 2) reduced braking and noise from the affected wheel, or 3) severing of a brake hose, increased brake pedal travel, and reduced steering control. If this were to occur, it could result in a vehicle crash without prior warning. Correction: Dealers will tighten both bolts to the specified torque.
On certain vehicles, a combination of a low battery condition and fuel in the upper intake manifold while the ignition key is activated at engine start could cause an elevated rate of manifold over-pressurization events. The operator may experience a loud bang / intake backfire that could rupture the intake manifold, resulting in emitting dust from under the hood and a no-start condition. If this event were to occur, and if an ignition source were present, an engine compartment fire could occur. Correction: Dealer will replace the fuel pressure regulator.
Certain vehicles do not comply with CMVSS 225 and 210.2. The Owner's Manual does not include the location symbols for the Lower Universal Anchorage System for Restraint Systems and Booster Cushions and an explanation of the meaning of the symbols. Correction: Owner's will receive an Owner's Manual supplement.
On certain vehicles, the driver's side air bag may not deploy as designed, resulting in reduced capability of the air bag to protect the driver. In addition, the air bag inflator may fracture. If this were to occur, pieces of the inflator could strike and injure the vehicle occupants. Correction: Dealer will inspect, and if necessary, install a new driver's air bag.
Certain vehicles may have a driver's side airbag inflator that could fracture at a weld during a deployment. Pieces of the inflator could strike and injure vehicle occupants and the airbag cushion would not inflate fully, reducing the capacity of the bag to protect the driver. Correction: Dealers are to inspect and if necessary replace the driver side airbag module assembly.
Certain vehicles do not comply with the requirements of CMVSS 101 - Location and Identification of Controls and Displays. Vehicles exhibit a condition in which the "Oil Warning Light" will not illuminate under low/no oil pressure conditions. Correction: Dealers will reflash the vehicle PCM with new calibration software.
Certain vehicles do not comply with the requirements of C.M.V.S.S. 209 - Seat Belt Assemblies. Vehicles may have seat belt assemblies that will not withstand the force requirements of the standard. In a crash, if the belt buckle fails, there is an increased risk of injury to the occupant. Correction: Suspect buckle assemblies will be replaced.
On certain vehicles, the airbag sensing and diagnostic modules (SDM) could experience a memory error resulting in the airbags not deploying in a crash situation. In a vehicle crash, a front seat occupant may receive more severe injuries. Correction: Dealers will replace the sensing and diagnostic module.
Subscribe for the latest car reviews, listings, products and more right in your inbox.
By clicking 'Subscribe', I agree to receive communications from AutoTrader. I can unsubscribe at anytime. I also agree to the Terms of Use and Privacy Policy.